250r pics, rich mark and everyone else.

hillbillyhpower · **Posted:** Mon Dec 15, 2008 8:51 pm

88 89 cylinders dont have the bridging, im starting to get confused

deerchooper · **Posted:** Mon Dec 15, 2008 9:38 pm

new to me mark,

. i do beleave the 87 88 89 cylinder had the bridging and the 86 didnt. idk

well the motor is in 2001 pieces right now. need to keep them seperated from the 450,

.

it has a hinson clutch basket in it, but its trashed, damit.

crank is out of spec's. little this and that and it should be ready to go.

im going to take the cases and such and have them hot tanked to start over all pretty.

deerchooper · **Posted:** Thu Dec 18, 2008 9:05 pm

oh no, something is wrong

deerchooper · **Posted:** Sun Dec 21, 2008 5:31 pm

i was told these were jd a arms, do they look it? idk just checking.

rich250rracer · **Posted:** Sun Dec 21, 2008 8:23 pm

deerchooper wrote:

i was told these were jd a arms, do they look it? idk just checking.

Possibly. They look a little like Laeger too.

deerchooper · **Posted:** Thu Jan 01, 2009 11:52 pm

well, this is supost to be a slow, take my time, wait for extra money build being im working on the 450 right now. but ebay and the internet forums just kill me.

so far i got new to me,

front motor mounts and head stay
a super tight kick lever
gasket kit
clutch and stator cover
cylinder in good shape, but will bore it
spare axle
repair manual
electrical do flicky
throttle cable
couple other a arms and some other things in a box

the frame, a arms, swinger, axle and stem are getting sand blasted tomorrow. found a guy local that will pc these parts cheap when i get my powder. plus i got a buddy that will do the small parts for me when im ready.

deerchooper · **Posted:** Mon Jan 05, 2009 7:52 pm

well i got my a arms back from the blaster today, i never noticed this on the a arms before i posted this,

.

lookie what i found on them,

.

deerchooper · **Posted:** Mon Jan 19, 2009 7:27 pm

well, heres pics of the frame. as you can see they had some gussets on the lower rear frame to sub mount. i cut them out because they looked like shlt and i will reweld in some new ones. also you can see where the top steering hoop is broke. i cut it with a cut off wheel so i get 100% weld and i might add a little support as well here. if you look at the close up inbetween the top head stay holes you can see its been welded there as well, i dont think thats factory but i will beaf that up to.

covey88 · **Joined:** Sun Oct 12, 2008 12:48 pm **Posts:** 129

so what is this R going to be used for? MX :lol:

or you building for play?

deerchooper · **Posted:** Mon Jan 19, 2009 7:47 pm

no mx here buddy,

.

maybe a little of both, tt/ hs and play

ChopRacing

250r pics, rich mark and everyone else.

Who is online